Filter
Top Products
Getting Started
27
English
2.3 Sequential Display Mode Error Messages
2.4 SD Memory Card Error Messages
Error Message Causes and Solutions
Sequential Display mode
is active.
Set mode switch on back
of unit to NORMAL, then
turn unit off/on. (EG1)
This error is displayed when the remote control is
used during sequential display mode.
• To use the BL-WV10 in normal operation
mode, set the mode switch to NORMAL, then
turn the BL-WV10 off and then on again.
Error Message Causes and Solutions
SD Memory Card is
locked.
Unlock the SD Memory
Card and try again. (EJ1)
This error is displayed when an SD memory card’s
write-protection is on.
• Turn the write-protection off.
No SD Memory Card.
Insert card and try again.
(EJ2)
This error is displayed if an SD memory card has not
been inserted.
• Insert an SD memory card.
SD Memory Card is full.
(EJ3)
This error is displayed if there is no free space on the
SD memory card.
• Insert a blank SD memory card, or erase
unneeded data from it.
Cannot use this SD
Memory Card. (EJ4)
This error is displayed when an SD memory card not
recognized by the BL-WV10 is used.
• Use a recognizable SD memory card or
format it using the BL-WV10 (see “Viewing
SD Memory Card Information” on page 106 of
the Operating Instructions).
Could not format. (EJ5) This error is displayed when memory card formatting
fails.
• Re-format the card. If that fails to correct the
problem, use a different SD memory card.
BL-WV10_GS-en.book Page 27 Wednesday, January 25, 2006 5:18 PM