Filter
Top Products
Getting Started
19
English
reconnect the DC cord, then continue from “Viewing Camera Images” on
page 19. If images can be viewed from all cameras, disconnect devices as
necessary and place them where you plan to use them.
1.5 Viewing Camera Images
To start up the BL-WV10 to view camera images, make sure the mode switch on
the rear of the unit is set to NORMAL and turn on the BL-WV10. The startup screen
appears. If the [Date and Time] screen appears, set the date and time (including
Daylight Saving Time start and end dates, if needed), then press ENTER. The
camera image should then appear.
While viewing camera images, you
can aim the camera by panning and
tilting the lens using the navigator
keys.
Pressing DISPLAY repeatedly
displays different camera and image
information.
Pressing ENTER aims the camera at
the camera’s home position.
Pressing buttons 1—8 on the remote
control aims the camera at the
corresponding preset position (if
registered).
You can also zoom in or out by
pressing and holding the up or down
navigator keys.
For more information, see “Viewing
Camera Images” on page 35 of the
Operating Instructions.
DISPLAY
ENTER
Navigator keys
BL-WV10_GS-en.book Page 19 Wednesday, January 25, 2006 5:18 PM