Filter
Top Products
Getting Started
38
3.9 Camera Indicator
Issue Causes and Solutions
After turning the power on,
the indicator is either solid
amber or flashing amber.
The Ethernet cable is not correctly connected.
• Re-connect the Ethernet cable.
The router is not working properly.
• Check the router.
You are attempting to connect a wireless camera with
a wired/wireless switch, such as the BL-C30, in wired
mode but the wired/wireless switch is set to wireless,
or you are attempting to work in a wireless mode and
the wired/wireless switch is set to wired.
• Set the switch to the appropriate setting.
The indicator continues to
flash green.
The Quick Setup settings are incomplete.
• Re-perform Quick Setup.
The indicator continues to
flash red.
There is something wrong with a camera.
• Contact your dealer.
The indicator is red. Privacy mode is turned on.
• Either press the PRIVACY button on the front
of the camera or turn off privacy mode (see
“Camera Setup for Local Cameras” on
page 93 of the Operating Instructions).
The indicator does not
turn green when using the
wireless LAN.
The wireless signal between the BL-WV10 and the
wireless camera is poor.
• Change the camera location, remove any
potential obstructions and try the connection
again.
BL-WV10_GS-en.book Page 38 Wednesday, January 25, 2006 5:18 PM