Filter
Top Products
Getting Started
30
3 Troubleshooting
3.1 General Issues
Issue Causes and Solutions
The unit doesn’t turn on. Is it plugged in correctly?
The remote control
doesn’t work.
Are the batteries good and installed correctly?
Is the remote control receptor in direct sunlight?
Is there an obstruction (including colored glass in a
rack door) between the remote control and the
receptor?
Is the mode switch on the back of the BL-WV10 set
to SEQ. DISP.?
• Set the mode switch to NORMAL and turn the
power on again.
The remote control
doesn’t turn the TV on.
Is the power button for the TV turned on?
Is the correct manufacturer code set for the remote
control?
The unit doesn’t seem to
work.
Is the power indicator flashing red?
Did the buzzer sound 3 or more times?
• Remove the power cord from the AC adaptor
and re-insert it. If this doesn’t resolve the
problem, contact your dealer.
I forgot the administrator
password and/or security
code.
Reset the BL-WV10 to its default settings.
• With the power on, press and hold the
FACTORY DEFAULT RESET button at the
back of the BL-WV10 with a paper clip tip or
similar object for 3 seconds.
[Application] or [CGI] are
not displayed in the
[Status] tab on the [Local
Camera Setup] screen.
Return to the camera list, select the camera again,
then select [Status].
BL-WV10_GS-en.book Page 30 Wednesday, January 25, 2006 5:18 PM