Filter
Top Products
67
6-4 Settings with a Web Browser (1. Other Settings) (continued)
Note
• Password Protection Function
VN-C10 is equipped with a security function for restricting browser (user) access. For this
function, there are three access (security) levels according to the authorization status. The
table below shows the accessible pages for each status.
(For the VN-C10 Web page structure, refer to page 62.)
Authorization Status Accessible VN-C10 Pages
User Still image and moving image pages
Operator Web pages except the setting pages
Administrator All Web pages
Item Effect
Default Page (continued)
Available/ Not available Select [Available] to enable the Default Page function or [Not
Available] to disable it.
File Name Enter the file name to be used as the default page.
HTTP Port It is possible to enhance the security level by setting the HTTP
server port number to other than the default value “80.” (Value
range: (1 through 65535 excluding 21 and 554) The new HTTP
port number can be accessed with a Web browser. If the port
number is changed to, for example, “12345,” it can be accessed as
http://192.168.0.2:12345 or http://192.168.0.2:12345/index-
e.html. If the HTTP port number is unknown, refer to [V.Networks
Setup Tool].
NTP Settings For settings of the NTP (Network Time Protocol) server.
Available/ Not available Select [Available] to enable the NTP server function or [Not
Available] to disable it.
Server IP Address Enter the NTP server IP address.
Timezone Obtains the local time based on the Greenwich Mean Time.
Adjust Interval Rectifies time deviation by acquiring the correct time from the
NTP server at a specified interval.
Caution
● Password setting cannot be released or changed unless the administrator password is en-
tered correctly. Do not forget the administrator password.
● Password entry is not required if the user and operator passwords are set, but not the one
for the administrator. The confirmation message, “Are you sure to RESET the camera to
enable the changes?” appears. Pressing [OK] for this message prompts VN-C10 to activate
its internal reset function, changing the IP address, etc. The previous, factory-set, IP ad-
dress is no longer in effect, and connection to VN-C10 will be cut off. If there is no keystroke
or mouse movement to the Web browser for a while, a message saying that connection
cannot be established appears. This is due to the IP address change. (Changing the port
number results in the same action.)
VN-C10_E_62-78.pm65e 14/04/03, 10:19 AM67