Filter
Top Products
28
This section describes alarm setting.
Alarm input is activated in the following cases.
• Input signals are received from an input terminal located on the rear panel of the camera, [ALARM
INPUT 1] or [ALARM INPUT 2]. (
☞ Page 16)
• Motion has been detected. (
☞ Page 30)
Operation when alarm input is activated.
• Output signals are sent from the output terminal located on the rear panel of the camera, [ALARM
OUTPUT]. (
☞ Page 17)
• Alarm information is reported to [V.Networks Controller.] (
☞ Page 29)
• Alarm Images are recorded. (
☞ Page 32)
1.
Start up [V.Networks Setup Tool] and select [Alarm].
2-4 Other Settings with V.Networks Setup Tool [
2. Alarm Setting]
Preparations (Step 2 Setting the Network)
14
5
6
2
3
7
8
2.
When the setting is complete, select [Apply] and then .
VN-C10_E_01-43.pm65e 14/04/03, 10:13 AM28