Filter
Top Products
infiNET™ Thermostat Crestron CHV-TSTATRF
Setup Mode Parameters/Functions (Continued)
PARAMETER/
FUNCTION
CODE VALID VALUES
DEFAULT
VALUE
NOTES
Check Battery Life bA
Not started (--)
Estimated remaining
battery life (0 – 99)
N/A
Gives estimated remaining
battery life in percent.
Restore Factory
Defaults
Fd
Not started (--)
In progress (flashing --)
Finished (00)
Button not held long
enough (Er)
N/A
Restores all setup parameters to
their default settings. To prevent
accidentally performing this
action, you must press and hold
either the or button for
three seconds for this function to
execute.
Perform Heat Call Test
(Toggle)
H
Not started/Heat call off
(--)
Heat call on (on) (also,
“H” icon will turn on)
N/A
Will test the heat call output.
Bypasses short-cycle timers.
Useful for technician system
testing. Note that calling the
heat may activate other relays in
the thermostat as required, such
as the fan output for heat pump
or dual-fuel types.
Perform Cool Call Test
(Toggle)
C
Not started/Cool call off
(--)
Cool call on (on) (also,
“C” icon will turn on)
N/A
Will test the cool call output.
Bypasses short-cycle timers.
Useful for technician system
testing. Note that calling the
cooling may activate other
relays in the thermostat as
required, such as the fan output.
Perform Aux Heat Call
Test (Toggle)
(will appear only on
Heat pump and Dual-
Fuel Heat pump
systems)
A
Not started/Aux call off
(--)
Aux call on (on) (also,
“A” icon will turn on)
N/A
Same as above, for testing aux
heat output.
Perform Fan Call Test
(Toggle)
F
Not started/Fan call off
(--)
Fan call on (on) (also,
“F” icon will turn on)
N/A
Same as above, for fan. Note
that only the fan relay can be
activated for a fan call test.
Perform Self Test St
Not started (--)
In progress (flashing --)
Finished, self test ok
(00)
Finished, self test failed
(E#, where # represents
an error code)
N/A
Performs a self-test of the
thermostat.
”E0” indicates low battery
voltage (replace batteries).
”E1” indicates low HVAC system
voltage (check supply voltage –
must be at least 24 VAC or 30
VDC).
”E5” indicates no gateway
information (acquire the device
to a C2N-MNETGW).
”E2”, “E3”, “E4”, “E6”, “E7”
reserved (serious errors, contact
tech support).
22 • infiNET™ Thermostat: CHV-TSTATRF Operations & Installation Guide – DOC. 6490