Filter
Top Products
Crestron CHV-TSTATRF infiNET™ Thermostat
Setup Mode Parameters/Functions (Continued)
PARAMETER/
FUNCTION
CODE VALID VALUES
DEFAULT
VALUE
NOTES
Power Source Po
24V always available
(24) or steal power (SP)
24
Selects source of input power
for thermostat. 24VAC assumes
constant power is available
between the C and RH
connectors. The steal-power
function allows recovery of
some power from the HVAC
system when constant power is
not available. Steal power may
not work with some zone
controllers. In this case, set
value to “24” and ensure that
you have two AA batteries
installed.
Check Firmware
Version
rE
Firmware version is
displayed in xx.yy.zz
format. “—“ can also be
displayed
--
When firmware version is not
yet shown, display will be “—“.
Each press of the or
button will cycle to the next
portion of the version number.
InfiNET ID (MNET ID) id 01 and 03 – FE 01
Sets the infiNET ID. SIMPL
Windows restricts infiNET
devices to an ID range of 03 –
20.
InfiNET RF Channel Ch
11-26 for fixed-channel
operation, “Au” for auto
or “0” for disabled
(battery saver)
26
Selects the RF channel. A fixed
channel allows faster setup and
reconnect when the gateway
channel is fixed. Auto channel
allows more flexibility but may
consume slightly more power if
network communications are
interrupted. A setting of “0”
disables the radio.
InfiNET Sleep Time SL Short (S) or Long (L) L
Indicates thermostat update
rate. Setting for fewer updates
(“L”) will conserve battery
power.
Start infiNET Acquire Ac
Not started (--)
In progress (flashing --)
Finished, found GW
(00)
Finished, could not find
GW (E#, where #
represents an error
code)
N/A
Used to acquire the device to a
gateway.
”E0” indicates that search time
has expired and no gateway
was found.
”E1” indicates the infiNET RF
Channel is set to “0” (disabled).
Unacquire Gateway UA
Not started (--)
In progress (flashing --)
Finished, success (00)
Finished, failed (E#,
where # represents an
error code)
N/A
Used to remove gateway
information from the device, so it
will no longer communicate with
the current gateway.
”E0” indicates that there is no
previous gateway information
(i.e. the gateway may already
have been unacquired).
(Continued on following page)
Operations & Installation Guide – DOC. 6490 infiNET™ Thermostat: CHV-TSTATRF • 21