Filter
Top Products
Crestron CHV-TSTATRF infiNET™ Thermostat
NOTE: An infiNET device can be acquired by only one gateway.
Put the C2N-MNETGW in the Acquire mode, from the unit itself by pressing
ACQUIRE or from Toolbox, as described in the latest revision of the
C2N-MNETGW guide (Doc. 6317), which is available for download from the
Crestron website (http://www.crestron.com/manuals
). The gateway ACQUIRE LED
lights.
NOTE: In environments where multiple gateways are installed, only one gateway
should be in Acquire mode at a time.
Press and simultaneously on the CHV-TSTATRF to start the acquire process:
display shows flashing “—” (in progress). When finished, display shows “00”
(finished, found gateway) or “E#” (finished, could not find gateway), where #
represents an error code.
NOTE: “E0” indicates that search time has expired and no gateway was found.
“E1” indicates the RF channel is set to “0” (disabled). To enable the RF channel,
refer to “infiNET RF Channel” in “Setup Mode Parameters/Functions” which starts
on page 19.
NOTE: To cancel an acquire process before it has completed, press the
and
buttons simultaneously.
After the process is complete, take the C2N-MNETGW out of the Acquire mode by
pressing ACQUIRE on the gateway. Refer to the latest revision of the
C2N-MNETGW guide (Doc. 6317).
To exit from Setup mode, press the FAN button on the CHV-TSTATRF.
The Fan icon will indicate the status of infiNET communication:
• Solid (non-blinking): Communication with control processor established
via gateway.
• Two brief blinks every eight seconds: Communication with gateway
established but control system is not addressing this MNET ID. It is
possible the MNET ID of the device (or the gateway ID) is not set to match
the MNET ID of the D3 Pro, SystemBuilder or SIMPL Windows program.
Use the Network Device Tree in Crestron Toolbox to poll the infiNET
network. Verify that the MNET ID for the infiNET device is set to match
the MNET ID specified in the program. Check the D3 Pro, SystemBuilder
or SIMPL Windows program to ensure that a CHV-TSTATRF has been
added at the proper MNET-ID. Refer to “Programming with Crestron D3
Pro or SystemBuilder” on page 27 or “Programming with SIMPL
Windows” on page 28.
• Four brief blinks every eight seconds: No communication with gateway
established. Refer to “Troubleshooting” on page 32 for details.
Operations & Installation Guide – DOC. 6490 infiNET™ Thermostat: CHV-TSTATRF • 17