Filter
Top Products
C
ONNECTING
THE
MAIN
POWER SOURCE
UGH016/0500 Series 1 Portable Chillers, TIC Control
INSTALLATION 3-9
WARNING: Improper installation, oper-
ation, or servicing may result in equip-
ment damage or personal injury.
This equipment should only be installed, adjust-
ed, and serviced by qualified technical person-
nel who are familiar with the construction, oper-
ation, and potential hazards of this equipment
All wiring, disconnects and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the machine serial tag and data
plate.
WARNING: Electrical hazard
Before performing any work on this item, dis-
connect and lock out electrical power sources to
prevent injury from unexpected energization or
startup.
Open the chiller’s electrical enclosure.
Connect the power wires to the terminals
as indicated on the wiring diagrams
that came with your machine. Route
the power cable through the hole in
the side of the chiller to the electrical
enclosure.
Check terminal screws to
make sure wires are secure. Gently
tug each wire; if wire is loose, use a
screwdriver to tighten the terminal.
Connect the ground wire to grounding lug.
1
2
3
4
The 575V, 1 1/2 - 4 Hp
units utilize a transformer;
power wires must be con-
nected to the line side of
the transformer.
Grounding lug