Filter
Top Products
UGH016/0500 Series 1 Portable Chillers, TIC Control
INSTALLATION 3-7
Temperature of Process Fluid °F
Glycol, % by Volume
Close the To Process and From Process valves.
Open the Fill/Drain valve and fill chiller
to the fill mark on the Water Level gauge. If the chiller is
overfilled, the excess fluid spills out the vent tube. DO
NOT OVERFILL.
Close the Fill/Drain valve.
Check the coolant level.
Once the chiller is turned on, the coolant level may drop
as the coolant begins to circulate, filling the connected
plumbing. Check the coolant level on the back of the
chiller. The water level shows on the water level gauge.
Make sure water level is filled to the mark on the gauge.
Change the minimum operating temperature
range to the correct setting for the percent glycol used.
See Setting the To Process Low Limit, in the Operations
section.
2
3
4
5
6
F
ILLING THE
CHILLER
CONT’D