Brother Z-8550A Pet Fence User Manual


 
Z-8550A, 8560A
10.
A
PPLYING GREASE (When “G
r
EASEUP” appears)
87
After applying grease in the places indicated by arrows [A] to [G] above, carry out the reset operation described below.
10-3. Resetting the cumulative operating time
After the grease has been applied, carry out the following
procedure to reset the cumulative time between grease
applications.
1. Turn the power switch to “ON”. “GrEASEUP” will flash in
the main display (1) and the buzzer will sound.
2. Press the RESET key (2). The main display (1) will switch
to zigzag width/zigzag base line position display mode.
3. Press and hold the LOCK key (4) for 2 seconds or
more.The lock icon (5) will switch off and the lock will be
released.
4. Press the FUNC (Function) key (6). “n.134 xxx” will
appear in green in the main display (1).
(xxx represents the time between grease applications.)
5. Press the rightmost key (7). The “
” will change to “0”.
6. Press and hold the ENTER key (8) for two seconds or
more.
A long beep will sound and the main display (1) will
switch to zigzag width/zigzag base line position display
mode.
7. Depress the treadle to run the sewing machine for 1
second or more.
8. Turn the power switch to “OFF”. (This completes the
reset procedure.)
3489M
Use the tip of a long brush or similar to
apply approx 1g of grease to the places
indicated by arrows [E] to [G].
3488M
2. Apply approx 1g
of grease.
1. Pull the needle bar (3)
forward with your finger.
3. Turn the machine pulley to gentl
y
apply the grease onto the felt.
4. Move the needle bar (3) back and
forth with your finger to spread
the grease.
A
fter applying approximately 1g of grease to
the groove, move the needle bar (3) back and
forth with your finger to spread the grease.
Felt