Brother Z-8550A Pet Fence User Manual


 
Z-8550A, 8560A
3. FUNCTION SETTINGS
21
3-7. DIP switch setting method
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the cover of the control box. Touching areas where high voltages are present can result in severe
injury.
ON Presser foot lowers (models for Europe)
1
Presser foot position when the treadle is
returned to the neutral position after thread
trimming
OFF Presser foot stays lifted (models for other than Europe)
(*1)
ON Enabled (models for Europe)
2
Presser foot lowering when treadle is
depressed to 1
st
step
(*2)
OFF Disabled (models for other than Europe)
ON Key lock function available
3 Operation panel key lock
OFF Key lock function not available
4 - Always set to OFF (*3)
(*1) If the knee switch is used to momentarily lower the presser foot, the presser foot cannot be raised by operating the
treadle when the sewing machine has stopped.
In such cases, the presser foot can only be lifted and lowered using the knee switch.
(*2) Adjustment of the treadle unit is required when changing this function.
Change the hooking position of the spring inside the treadle unit, and set the depression stroke. (Refer to “12. TREADLE
UNIT”.)
(*3) When set to ON, treadle operation is disabled, so it should always be set to OFF.
If it is set to ON, [DIP SW4] (green) and [Err 101] (orange) will appear alternately in the main display of the operation
panel.
3579M