Brother Z-8550A Pet Fence User Manual


 
Z-8550A, 8560A
3. FUNCTION SETTINGS
5
Memory switch No. 16 - 30
No. Initial value Setting range Setting details
16 3 (minutes) 0 - 30 (minutes)
Overtime function
0: None
1-30: After continuous operation for the set length of time, operation stops
and [Err 190] is displayed.
17 1 0 - 3
Correction stitch function (correction stitch icon [when off/when on]
operation)
0: Half stitch correction sewing / Single stitch correction sewing
1: No correction sewing / Single stitch correction sewing
2: Reverse correction sewing (reverse feed) / Single stitch correction sewing
3: Forced single stitch sewing after thread trimming / Single stitch sewing
18 50 (ms) 10 - 200 (ms)
19 50 (ms) 10- 200 (ms)
20 50 (ms) 10 - 200 (ms)
Thread wiping and presser foot lifting timing after thread is trimmed and
sewing stops
21 0 0 - 1
Start backtacking operation
0: Stitch Nos. A, B (N backtacks)
1: Stitch Nos. A, B, A, B (N backtacks doubled)
22 0 0 - 1
End backtacking operation
0: Stitch Nos. C, D
1: Stitch Nos. C, D, C, D (N backtacks doubled)
26 0 0 - 1
Speed when changing to end backtacking
0: Speed decelerates to low speed, then end backtacking starts
1: Speed decelerates to end backtacking speed, then end backtacking starts
(allows shortening of cycle time)
27 0 0 - 1
Continuous backtacking operation
0: Stitch Nos. A, B, C, D
1: Stitch Nos. A, B x D times
28 0 0 - 1
Feed direction when sewing is stopped immediately after start backtacking is
complete
0: Quick reverse solenoid turns off and feed returns
to normal direction, then stops
1: After sewing stops, the quick reverse solenoid
turns off (if No. 31 is set to “0”, sewing starts again
when the treadle is depressed slghtly
30 150 (ms) 0 - 500 (ms)
Delay time for motor to start when presser foot is lifted and sewing machine
starts operating when automatic presser foot lifting is being used
Motor
Thread wiping
(Fully ON)
Needle up
t
2245M
2246M
Presser
foot lifting