Filter
Top Products
Z-8550A, 8560A
3. FUNCTION SETTINGS
11
Memory switch No. 111 - 123
No. Initial value Setting range Setting details
111 1000 (rpm) 500 - 2000
Limit speed for sewing patterns with changed sewing pitch (T stitches)
Needle lifting and needle lowering are carried out at low speed when No. 110
is set to “1”.
112 1 0 - 1
Low speed limit when sewing machine motor starts
0: No limit
1: When not at the needle up or needle down position, the needle bar speed is
limited to low speed until the needle up or needle down position
113 0 0 - 1
Changing speed using speed bar while sewing machine motor is operating
0: Can be changed
1: Cannot be changed
114 0 0 - 1
Operation when auto function is on (fixed stitch/name label sewing)
1: Automatic thread trimming is not carried out after fixed stitch/name label
sewing is complete
0: Automatic thread trimming is carried out after fixed stitch/name label sewing
is complete
115
1.0
(1.0 ms)
0.1 - 4.9
(0.1 - 4.9 ms)
On time for solenoid-type presser lifter solenoid during chopping
Enabled when No. 37 is set to “0”.
116
2.5
(2.5 ms)
0.1 - 4.9
(0.1 - 4.9 ms)
On time for pneumatic-type presser lifter solenoid during chopping
Enabled when No. 37 is set to “1”
117
1.1
(1.1 ms)
0.1 - 4.9
(0.1 - 4.9 ms)
On time for quick reverse solenoid during chopping
118
85
(85 ms)
40 - 100
(40 - 100 ms)
Fully on time for quick reverse solenoid
119 1 0 – 2
Correction level when 2-step zigzag direction is reversed (“0” means no
correction)
* Enabled when zigzag width setting is 4.0, 4.2, …
120 2 0 - 3
Correction level when 3-step zigzag direction is reversed (“0” means no
correction)
* Enabled when zigzag width setting is 4.8 or higher
121 1 0 - 2
Correction level when 2-step zigzag direction is reversed (“0” means no
correction)
* Enabled when zigzag width setting is 4.1, 4.3, …
123 45 (degrees)
30 - 90
(degrees)
Servo lock release rotation angle [Do not change this setting.]
Presser foot lifting
(Fully on)
Presser lifting
(Fully on)
Quick reverse solenoid
(Fully on)
2264M
2266M
2265M