Filter
Top Products
8. CHANGING THE FEED AMOUNT TO LONG STITCH SPECIFICATIONS (from 2.0mm to 5.0mm)
Z-8550A, 8560A
65
5. Turn the stitch length dial (7) and the condense dial (8) to
the maximum feed amount for the feed dog being used.
(Set the condense dial (8) to a negative number.)
6. Check that the feed dog does not touch the needle plate
both when the reverse stitching lever (9) is not lowered and
when it is lowered.
If it touches, adjust the forward/back installation position
(centering) of the feed dog.
7. Without lowering the reverse stitching lever (9), move the
stopper (5) up until it touches F-regulator connecting rod
(10), and then tighten the screw (3). [Fig. A]
8. With the reverse stitching lever (9) lowered all the way,
move the stopper (6) down until it touches the F-regulator
connecting rod (10), and then tighten the screw (4). [Fig.
B]
3502M
1179B
[A]
[B]
1180B
3501M
3501M