Brother Z-8550A Pet Fence User Manual


 
Z-8550A, 8560A
3. FUNCTION SETTINGS
10
Memory switch No. 90 - 110
No. Initial value Setting range Setting details
90
160
(rpm)
150 - INCH
(rpm)
Thread trimming speed (TRIM)
91
220
(rpm)
150 - 300
(rpm)
Low speed (INCH)
92
1400
(rpm)
500 - 2500
(rpm)
Stop improvement position (POS)
[Do not change this setting.]
93
300
(rpm)
INCH - 1000
(rpm)
Slow speed (SLOW)
94
3000
(rpm)
INCH - 3000
(rpm)
Start backtacking limit speed (SBL)
(Upper limit for start backtacking speed setting)
96
1200
(rpm)
INCH - 3000
(rpm)
End backtacking speed (EBT)
98
HIL
(rpm)
INCH - HIL
(rpm)
Automatic sewing speed (AUTO)
99 (*1)
INCH - 5000
(rpm)
Maximum sewing speed limit speed (HIL) (*2)
101
8.0
(mm)
3.0 - 10.0
(mm)
Maximum zigzag width setting
102 0 0 - 1
Backtack zigzag width setting
0: Cannot be changed
1: Can be changed
103 0 0 - 1
Backtack selection when plain zigzag is selected
0: Plain zigzag
1: 3-step zigzag
104 0 0 - 2
Pattern reset when treadle is depressed backward
0: Starts from next pattern
1: Returns to start of patterns only if patterns 5 to 9 are selected
2: Returns to start of patterns when plain, 2-step or 3-step zigzag is selected
(patterns 2 to 9)
(Plain, 2-step and 3-step zigzag will be sewn at the position set by No. 105.)
105 0 0 - 1
Sewing start position when plain, 2-step or 3-step zigzag is selected
When stopped at left Free When stopped at right
0: Left edge Left edge Right edge
1: Right edge Right edge Left edge
This setting is enabled when No. 104 is set to “2”.
106 0 0 - 2
Blind stitch sewing start position
0: Zigzag section
1: Plain stitch section
2: Specified by the number of stitches
108 0 0 - 1
Sewing machine motor operation when [UP] is displayed
0: Disabled (hand operation only)
1: Operates (enabled when treadle depressed backward and half-stitch key is
pressed)
109 1 0 – 1
Needle zigzagging when treadle depressed backward
0: Disabled
1: Enabled
110 0 0 - 1
Sewing patterns with changed sewing pitch (T stitches)
0: Not possible
1: Possible
*1: Setting is read from machine head detection switch.
*2: This is the upper limit setting for the maximum sewing speed. Refer to “7-6. Setting the maximum sewing spped” of the
instruction manual for details on the maximum sewing speed settings.