Brother Z-8550A Pet Fence User Manual


 
Z-8550A, 8560A
4. USING CF CARDS
24
4-3. Preparation for reading/writing data
1
With the power turned off, insert the CF card into the CF slot.
NOTE:
Make sure the CF card is facing the correct way.
Always be sure to keep the cover closed except when inserting
and removing the CF card. If this is not done, dust may get inside
and cause problems with operation.
2
Turn on the power switch (1).
3
While pressing the TEST key, press the CF key to switch to CF card read/write mode.
The mode number will appear in (1) of the main display, and
the symbol name for that mode will appear in (2).
* The initial mode is additional sewing data reading mode
(r1). (Refer to the <Read/write mode list>.)
4
Select the mode.
The mode changes each time the key is pressed.
<Read/write mode list>
Mode No. Symbol name Setting items
r 1 [-SEd] Additional sewing data is read from the CF card into the sewing machine. *
w 2 [SEd-] Additional sewing data is written from the sewing machine to the CF card.
r 3 [-MEM] Memory switch settings are read from the CF card to the sewing machine.
w 4 [MEM-] Memory switch settings are written from the sewing machine to the CF card.
r 7 [-SyS] Control programs are read from the CF card and used to update the firmware version.
w 8 [LoG-] Error log data is written from the sewing machine to the CF card.
* The additional sewing data that can be use with this sewing machine is data that has been created for the
Z-8550A/Z-8560A.
0189B
4453Q
0190B
0188B
MEMO icon illuminates.
* If no valid data can be found on the CF card,
the MEMO icon will not illuminate.