Filter
Top Products
HE-800A
7. CORRECT USE
58
ዓ
-
ዎ
. Threading the upper thread
CAUTION
Turn off the power switch before threading the thread, otherwise the machine may operate if the treadle is
depressed by mistake, which could result in injury.
Thread the upper thread correctly as shown in the illustration.
ƒ When pulling the thread out from the zigzag thread tension (1), move the tension release lever (2) in the direction of
the arrow to open the tension discs (3) in order to make it easier to pull out the thread.
ƒ After threading the arm thread guide (4), pass the thread under the thread guide (5) as shown in the illustration to
make it easier to thread.
ƒ Push the needle bar to the right to make it easier to pass the thread through the needle.
Note:
ƒ If you start sewing without passing the thread through the thread guide (5), error “E-01” will be generated and the
sewing machine will stop.
ƒ The thread tension (6) is used to prevent the upper thread from becoming knotted, tangled or loose, so do not
touch it. It is tightened only gently. If it is tightened too firmly, the knob may become damaged.
Threading the thread at the sewing start position
1. Turn on the power and set the sewing machine to
the home position.
2. Press the RESET key (7).
* The work clamp will be lowered, and ”¯AdJ” will be
appear in the parameter display LED (8). The
sewing machine will not operate during this time,
even if the treadle is depressed.
3. Press the parameter UP key (9).
* The needle bar will move to the right to make
threading easier.
4. Press the RESET key (7).
* The needle bar will move to the center position
and the work clamp will rise.
3951Q
For spun thread and
cotton thread
For polyester thread
4100M
For threads which do not slide easily
Thread will get caught
or