Filter
Top Products
HE-800A
4. INSTALLATION
18
4) Installation underneath the work table
Standard BROTHER work tables are provided with installation holes for use in installing the transformer.
1. Remove the four screws (1), and then remove the two handles (2).
2. Use the bolts (4), flat washers (5), spring washers (6) and nuts (7) to install the transformer as shown in the
illustration, while leaving a gap of 2 mm between the work table and the cushion collars (3).
* Use the bolts, flat washers, spring washers, nuts and cushion collars which are included.
Connecting the cords
1. Loosen the four screws (1), and then remove the transformer cover (2).
2. Connect the control box connector (3) to the transformer connector (4).
3. Secure the connected cords with the cord holder (5) and the screw (6), and place them inside the transformer cover
(2).
4. Install the transformer cover (2) with the four screws (1).
5. Secure the cords to the work table using staples.
3878Q
Work table hole positions
2075Q 3877Q 3879Q
3880Q 3881Q