Filter
Top Products
HE-800A
5. OPERATION
54
ዑ
-
ውዏ
. Adding patterns created using the programming software for
electronic pattern sewer
You can use the programming software for electronic pattern sewer to create your own sewing patterns.
Up to nine of the patterns which you create in this way can be programmed into a P-ROM.
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall
outlet before opening the face plate of the control box. Touching areas where high voltages are present can
result in severe injury.
1. Remove the six screws (1), and then open the cover (main P.C. board mounting plate (2)).
Note: When opening the cover, hold it securely so that it does not fall down.
2. Remove the P-ROM (3) from the main P.C. board.
3. Create the pattern(s) using the programming software for electronic pattern sewer. Refer to the Operating
Instructions for the programming software for electronic pattern sewer for details on how to create patterns.
4. Add the pattern(s) created to the P-ROM (3).
5. Install the P-ROM (3) to the main P.C. board so that it faces as shown in the illustration.
Note: If attached in reverse way, P-ROM may be damaged.
6. Close the cover (main P.C. board mounting plate (2)), and tighten the six screws (1).
The program numbers for patterns which have been created using the programming software for electronic pattern
sewer range from P1 to P9. However, program numbers which have not yet been assigned to a program will not
appear on the program number LED.
ψ 1ψ 2ψ 3ψ……ψ 90ψ P1ψ P2ψ……ψ P9
You can check and change the following parameters for patterns which have been created using the programming
software for electronic pattern sewer.
No. Setting items Setting range Unit Default
00 Sewing speed (zigzag part) 1,000 - 4,000 sti/min 100 3,600
02 Length of knife Value is for checking purposes
and cannot be changed.
- -
08 Knife X position alignment -0.5 - 0.5mm 0.1 0.0
09 Knife Y position alignment -0.8 - 0.8mm 0.1 0.0
16 Running speed (Straight bar tack) 1,000 - 3,000 sti/min 100 2,000
48 Underlay speed 1,000 - 3,000 sti/min 100 2,000
60 Slow speed 500 - 1,500 sti/min 100 800
61 Rear tack speed 500 - 4,000 sti/min 100 4,000
62 Front tack speed 500 - 4,000 sti/min 100 4,000
3944Q 3945Q