Filter
Top Products
HE-800A
5. OPERATION
32
ዑ
-
ዐ
. Program setting method
The parameters for program numbers 1 to 90 are all set to their default values at the time of shipment. (Refer to “5-5.
Parameter table”.)
1. Press the SELECT key (1) to change the mode to automatic, test feed or manual mode.
2. Press the program No. keys (2) and (3) to select the program number (1 - 90) for the program to be changed.
* The program number will flash in the program number LED (4).
3. Press the ENTER key (5).
* The program number will be accepted and the program number LED (4) will stop flashing and illuminate steadily.
Note: The program number will not be accepted if the ENTER key (5) is not pressed.
4. Press the SELECT key (1) to change the mode to program mode.
* The parameter number for the program number that was selected above will appear in the program number LED
(4), and the parameter setting value will appear in the parameter display LED (6).
5. Press the program No. keys (2) and (3) to select the number for the parameter to be changed.
6. Press the parameter keys (7) and (8) to change the parameter setting, and then press the ENTER key (5).
* The parameter setting will be changed and the parameter display LED (6) will stop flashing and illuminate steadily.
Note: The setting will not be changed if the ENTER key (5) is not pressed.
7. Press the SELECT key (1) to change the mode to automatic mode.
The setting details can be saved in the program notes of the program memos for easy checking. (Refer to
“5-12. Using the program memos”.)
3909Q