Filter
Top Products
HE-800A
16. TROUBLESHOOTING
99
ውዒ
-
ውዏ
. Upper thread run out
Cause Check Remedy Page
Installation position of
upper thread trimmer
assembly
Adjust the installation position of upper thread
trimmer assembly by moving the setting plate
assembly.
Upper thread trimmer longitudinal position
adjustment
Upper thread trimmer cutting depth adjustment
Service
manual
Upper thread trimmer
assembly holding force
Adjust so that the thread does not come out when
you cut it with scissors and hold the end of the
thread between your fingers and gently swing the
assembly.
Bend the scissors U or replace them so that the
correct force is applied.
Repair any damage from striking the needle.
-
Upper thread
trimmer assembly
Opening cam position Adjust the position so that the scissors do not touch
the opening cam when the work clamp is lowered.
76
End of tension release at
the beginning of sewing
Use parameter number 63 to retard the tension
release timing.
44
Tension release
timing
Opening amount of
zigzag tension discs and
bar tack tension discs
Adjust the zigzag tension discs by moving the
tension stud bracket in and out.
Adjust the bar tack tension discs opening amount
to 0.5 - 1.0 mm by removing the top cover and
moving the tension release cam.
-
4006Q
4005Q
4107M
0.5 mm
Cotton yarn #60
Holding force approx. 2N
4008Q
Tack tension
0.5 - 1 mm
Zigzag tension