Filter
Top Products
HE-800A
6. CHECKING THE SEWING PATTERN
55
ዒ
. CHECKING THE SEWING PATTERN
You can check the sewing pattern which has been programmed, and also the needle zigzagging and feed operation.
Checking can be carried out using test feed mode, or by turning the machine pulley by hand in manual mode. These
two modes can also be combined in order to carry out checking.
ዒ
-
ው
. Test feed mode
1. Press the SELECT key (1) to change the mode to automatic mode.
2. Press the program No. keys (2) and (3) to select the number for the program to be checked, and then press the
ENTER key (4).
* The program number LED (5) will stop flashing and light steadily.
3. Press the SELECT key (1) to change the mode to test feed mode.
* The number of stitches in the selected program will appear as "H***" in the parameter display LED (6).
4. Depress the treadle from the neutral position [A] to the 2nd step [C].
* The work clamp will be lowered, and the needle zigzag and feed mechanisms will move to the sewing start
position.
5. Return the treadle to the neutral position [A], and then depress it once more to the 2nd step [C]. The needle zigzag
and feed mechanisms will each advance by one step while the treadle is being depressed.
* The needle zigzag and feed mechanisms will also advance by one step if you press the parameter UP key (7). The
needle zigzag and feed mechanisms will also retreat by one step if you press the parameter DOWN key (8).
* If the knife has been set to operate, the buzzer will sound and "C-On" will appear in the parameter display LED (6).
6. The machine will stop at the final stitch position, and "H o" will appear in the parameter display LED (6).
7. Return the treadle to the neutral position [A], and then depress it to the 2nd step [C]. The sewing machine will move
to the home position, and the work clamp will rise.
8. Press the SELECT key (1) to change the mode to automatic mode.
ƒ If you press the SELECT key (1) during the checking operation, the mode will change to manual mode. If you
press the SELECT key (1) once more, the mode will change back to test feed mode.
ƒ If you would like to stop checking before the operation has completed, press the RESET key (9). The sewing
machine will move to the home position, and the work clamp will move to the neutral position.
3946Q 3905Q