Filter
Top Products
HE-800A
4. INSTALLATION
17
ዐ
-
ውው
-
ዒ
. Installing the transformer
The transformer can be installed on the floor, on the work table leg (on top of the leg or on the treadle support plates)
or underneath the work table.
Check the power supply rating label on the transformer to confirm that the voltage ratings for the transformer and the
control box are identical.
1) Floor installation
Select a suitable location, and place the transformer
on the floor in that location.
* Select a location where the transformer will not be an
obstruction to people walking past.
2) Table leg installation (on top of table leg)
Secure the transformer to the top of the table leg using
the mounting bracket and screws.
* The mounting bracket and screws must be obtained
separately.
3) Table leg installation (treadle support plates)
1. Remove the four screws (1), and then remove the
two handles (2).
2. Place the transformer on top of the two treadle
support plates (3) as shown in the diagram, and
then secure it to the handle (2) using the washers
and screws.
* The washers and screws must be obtained
separately.
2071Q
2069Q
2070Q
Screw (M5 x 8)
Mounting
bracket
112.5mm
4035Q
3876Q
Washer
Screw (M6 x 14)
3875Q