Filter
Top Products
HE-800A
5. OPERATION
51
ዑ
-
ዕ
. Cycle program
Cycle program can contain up to a maximum of nineteen steps.
ψ C1ψ C2ψ C3ψ……ψ C9ψ C0.ψ C1.ψ……ψ C9.
This section shows an example where C1 is set to program number 3 and C2 is set to program number 10.
Step C1 C2
Program No. 3 10
1. Press the SELECT key (1) to change the mode to
program mode.
2. While pressing the ENTER key (2), press the
program No. UP key (3). Repeat this operation
twice.
* "C1" will appear in the program number LED (4).
3. Press the parameter keys (5) and (6) to select the
program number 3.
* The program number 3 will appear in the
parameter display LED (7).
4. Use the CUTTER ON key (8) to set whether the
cutter is turned on or off.
* If "." appears in the display, the cutter is turned on,
and if "." does not appear, the cuter is turned off.
However, if the cutter on indicator (9) is switched
off during cycle sewing, the cutter operation will
always be off.
5. Press the ENTER key (2) to accept the program
number 3.
* The display will stop flashing and illuminate
steadily.
6. Press the program No. UP key (3).
* "C2" will appear in the program number LED (4).
The numbers "3." [the program number for C1]
and "0." will appear in the parameter display
LED (7).
7. Press the parameter keys (5) and (6) to select the
program number 10.
8. Use the CUTTER ON key (8) to set whether the
cutter is turned on or off.
9. Press the ENTER key (2) to accept the program
number 10.
* The display will stop flashing and illuminate
steadily.
10. Press the SELECT key (1) to change the mode to
automatic mode. "C1" will appear in the program
number LED (4).
Clearing the cycle program
Program number "0" signifies a clear status. If "0" is set, the setting details for all subsequent steps will be cleared.
If C1 is set to "0", the cycle program will be cleared.
3940Q
Cutter on
Cutter off