Filter
Top Products
ICP-CC404 | Installation Guide | 6.0 System Functions
34 Bosch Security Systems, Inc. | 12/08 | F01U089401-02
6.2.4 Change Telco Arming or Disarming
Sequence
Program the call forward sequence to automatically
operate when you arm the system in AWAY Mode.
This feature is only available if the call forward option
is available from your telecommunication provider.
When arming the system in AWAY Mode, the
control panel dials the telecommunication exchange
to redirect all calls to your mobile phone, pocket
pager, or answering service. When activated, your
telephone still allows outgoing calls.
Contact your telecommunications provider for more
information on call forward operations.
Table 29: Telco Arming or Disarming Dialing
Digits
Digit
Required
Number to
Program
Digit
Required
Number to
Program
0 0 8 8
1 1 9 9
2 2 10 0
3 3 11 * 1
4 4 12 * 2
5 5 4 sec pause * 3
6 6 break * 4
7 7 15 * 5
To program the Telco arming sequence – easy
call forward (no answer on):
1. Enter your Master Code and press [3][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Press [1][AWAY] to change the Telco arming
sequence.
Three beeps sound.
If a call forwarding sequence is already
programmed, the sequence appears one digit at a
time using the remote codepad indicators. Refer
to Table 30 for the indicators and their meanings.
If there is no call forward sequence programmed,
an additional two beeps sound after entering this
mode. These two beeps normally sound after the
last digit of the call forward sequence is
displayed.
Table 30: Codepad Indicators When Changing
Telco Arming or Disarming
Sequence
Zone Indicators MAINS
Digit 1 2 3 4 5 6 7 8 Indicator
0 X
1 X
2 X
3 X
4 X
5 X
6 X
7 X
8 X
9 X X
11 X X
12 X X
Pause X X
Break X X
15 X X
3. Press [STAY][1 6 1] and enter the phone number
to which you want calls from the control panel
diverted.
4. Press [STAY][2][AWAY].
Two beeps sound and the system returns to the
disarmed state.
Example
If you want to automatically divert all unanswered
incoming calls to another telephone number (for
example, 9672 1777) when the system is armed in
AWAY Mode, enter:
[2 5 8 0 3][AWAY][1][AWAY][STAY]
[1 6 1 9 6 7 2 1 7 7 7][STAY][2][AWAY]
You can suspend the Telco arming sequence at any
time.
To disable the Telco arming sequence:
Enter your Master Code and press [3][AWAY][1]
[AWAY][STAY][4][AWAY].
To program the Telco disarming sequence – easy
call forward (no answer off):
1. Enter your Master Code and press [3][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Press [2][AWAY] to change the Telco disarming
sequence.
Three beeps sound.
If a Telco disarming sequence is already
programmed, the sequence appears one digit at a
time using the remote codepad indicators. Refer
to Table 30 for the indicators and their meanings.