Filter
Top Products
ICP-CC404 | Installation Guide | 6.0 System Functions
Bosch Security Systems, Inc. | 12/08 | F01U089401-02 29
When arming the system in AWAY Mode, the
control panel automatically dials the
telecommunication exchange to redirect all calls to
your mobile phone, pocket pager, or answering
service. When activated, your telephone still allows
outgoing calls.
Contact your telecommunications provider for more
information on call forward operations.
Table 22: Telco Arming or Disarming Dialing
Digits
Digit
Required
Number to
Program
Digit
Required
Number to
Program
0 0 8 8
1 1 9 9
2 2 10 refer to 0
3 3 11 * 1
4 4 12 * 2
5 5 4 sec pause * 3
6 6 break * 4
7 7 15 * 5
Table 23: Codepad Indicators When Changing
the Telco Arming or Disarming
Sequence
Zone Indicators MAINS
Digit 1 2 3 4 5 6 7 8 Indicator
0 X
1 X
2 X
3 X
4 X
5 X
6 X
7 X
8 X
9 X X
11 X X
12 X X
Pause X X
Break X X
15 X X
To program the Telco arming sequence – easy
call forward (no answer on):
1. Enter the Installer Code and press [3][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Press [1][AWAY] to change the Telco arming
sequence. Three beeps sound.
If a call forwarding sequence is already
programmed, the sequence appears one digit at a
time using the remote codepad indicators. Refer
to Table 23 on page 29 for the indicators and their
meanings.
If there is no call forward sequence programmed,
an additional two beeps sound after entering this
mode. These two beeps normally sound after the
last digit of the call forward sequence is
displayed.
3. Press [STAY][1 6 1] and enter the phone number
to which you want calls from the control panel
diverted.
4. Press [STAY][2][AWAY].
Two beeps sound and the system returns to the
disarmed state.
Example
If you want to automatically divert all unanswered
incoming calls to another telephone number (for
example, 9672 1777) when the system is armed in
AWAY Mode, enter:
[1 2 3 4 3][AWAY][1][AWAY][STAY]
[1 6 1 9 6 7 2 1 7 7 7][STAY][2][AWAY]
You can suspend the Telco arming sequence at any
time.
To disable the Telco arming sequence:
Enter the Installer Code and press [3][AWAY][1]
[AWAY][STAY][4][AWAY].
To program the Telco disarming sequence – easy
call forward (no answer off):
1. Enter the Installer Code and press [3][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Press [2][AWAY] to change the Telco disarming
sequence.
Three beeps sound.
If a Telco disarming sequence is already
programmed, the sequence appears one digit at a
time using the remote codepad indicators. Refer
to Table 23 on page 29 for the indicators and their
meanings.
If there is no Telco disarming sequence
programmed, an additional two beeps sound after
entering this mode. These two beeps normally
sound after the last digit of the sequence is
shown.
3. Press [STAY][2 6 1][STAY][2][AWAY].
Two beeps sound and the system returns to the
disarmed state.
You can suspend the Telco disarming sequence at
any time.