Filter
Top Products
ICP-CC404 | Installation Guide | 5.0 Remote Radio Transmitter Operations
26 Bosch Security Systems, Inc. | 12/08 | F01U089401-02
If horn speaker indication beeps are enabled, one
two-tone beep sounds from the horn speaker. If
strobe indications are enabled, the strobe flashes for
6 sec to indicate the system is armed.
5.4.4 Disarming from STAY Mode 1
Press and hold either the black or green button for
2 sec.
Two beeps sound on the remote codepad and the
STAY indicator is extinguished.
If horn speaker indication beeps are enabled, one
beep sounds from the horn speaker. If strobe
indications are enabled, the strobe flashes for 3 sec to
indicate the system is disarmed.
5.4.5 Panic Alarm
Press and hold both the black and green buttons
together for 2 sec.
An audible Panic Alarm is initiated that activates the
horn speaker, strobe, and internal sirens.
If Option 1 is selected in Location 425
(refer to Section 18.2 System Options 2
on page 73), the remote radio Panic
Alarm is also silent.
5.5 Four-Channel Remote Radio Hand-
Held Transmitter Operations
Because all operations using the four-channel remote
radio hand-held transmitter are fixed after the control
panel learns the hand-held transmitter’s code, no
programming is required for the transmitter buttons.
You can use the DOOR and AUX buttons on the
transmitter to operate the control panel’s
programmable outputs (garage door or outside lights,
for example).
Figure 5: RE013/E: 4-Channel Keyfob
Transmitter
3
2
1
4
1 – Button 1: Arm or disarm in AWAY Mode
2 – Button 2: Arm or disarm in STAY Mode
3 – Buttons 1 and 2: Press both buttons at the
same time to activate Panic alarm.
4 – Buttons 3 and 4: Your security company
can program these buttons for optional
operation, such as operating a garage
door.
5.5.1 Arming in AWAY Mode
Press and hold [AWAY] for 2 sec.
Two beeps sound on the remote codepad and the
AWAY indicator lights. Exit Time starts.
If horn speaker indication beeps are enabled, two
beeps sound from the horn speaker. If strobe
indications are enabled, the strobe flashes for 6 sec to
indicate the system is armed.
5.5.2 Disarming from AWAY Mode
Press and hold either [AWAY] or [STAY] for 2 sec.
Two beeps sound on the remote codepad and the
AWAY indicator is extinguished.
If horn speaker indication beeps are enabled, one
beep sounds from the horn speaker. If strobe
indications are enabled, the strobe flashes for 3 sec to
indicate the system is disarmed.
5.5.3 Arming in STAY Mode 1
Press and hold STAY for 2 sec.
Two beeps sound on the remote codepad and the
STAY indicator lights. Exit Time starts.
If horn speaker indication beeps are enabled, one
two-tone beep sounds from the horn speaker. If
strobe indications are enabled, the strobe flashes for
6 sec to indicate the system is armed.
5.5.4 Disarming from STAY Mode 1
Press and hold [AWAY] or [STAY] for 2 sec.
Two beeps sound on the remote codepad and the
STAY indicator is extinguished.