Filter
Top Products
D1265 | Owner's Manual | Part IV: Multi-Area Use
60 Bosch Security Systems, Inc. | 9/10 | F01U169130-02
Part IV: Multi-Area Use
Working with Multiple Areas from a Single
Keypad
Each of the functions described in the preceding
section on Advanced Commands is presented as
though your system includes only one area. If your
system includes more than one area, it can be set up in
one of two ways by the installing company:
Each keypad only has access to the local area to
which it is assigned, or
Each keypad might access either some or all areas
beyond the one to which it is assigned. This factor
is referred to hereafter as keypad scope.
If your keypad allows access to areas other than the
local area (that is to say, has scope in other areas), then
the keypad limits your access to those areas within the
keypad scope and for which your personal passcode
has authority.
Given that you have access to areas beyond the local
area, the means of accessing the various system
functions depends upon the specific function.
For some functions, the keypad allows you to select the
area (or point) in which to perform the function. These
“selectable” functions are:
Disarm
Master Arm Area
Bypass A Point
Unbypass A Point
Another group of functions might automatically work
in all areas in which you have passcode authority and
which are within the scope of the keypad. These are:
Turning Off Multiple Areas with a Passcode
Disarm All
Master Arm All
View Alarm Memory
Walk Test
Reset Sensors
Add Passcodes
Fire test
View Point Status
View Area Status
Some functions might be area-specific. To perform
these functions, you must first use the Move To Area
function (CMD 50) to gain access to the desired area.
Once in the desired area you can perform the
functions you wish. Area-specific functions include:
Perimeter Instant (Perimeter On Instant)
Perimeter Delay (Perimeter On Delay)
Perimeter Partial (Perimeter On Partial)
Extend Closing
Watch Mode
CMD 7
CMD 9
A last group of functions don’t relate to specific areas
and are thus system-wide. These are:
Send Report
Remote Program
Change Time/Date
Change Skeds
Delete Passcodes
Change Relays
Change Passcodes
Print Log
View Log
View Area Status
Use this function when you need to know the status
(whether armed or disarmed) of areas other than the
one you’re in.
1. Ensure your keypad shows idle disarmed text.
2. Press the Menu button to enter the function list.
3. Press Next repeatedly until you reach the View
Area Status
button.
Press the button.
4. The display changes to show on the top line the
area name and the current status on the second
line.
Pressing the Next button changes the display to
the next area and remain for 20 sec or until the
Next
button is pressed for the next area. If the
time has elapsed, the display returns to idle text.
Pressing the Previous
button
changes the
display to the previous area.
5. Press the Exit button to return to idle text.