Filter
Top Products
D1265 | Owner's Manual | Part III: Advanced Commands
Bosch Security Systems, Inc. | 9/10 | F01U169130-02 47
Change Relay (CMD + 5 + 4)
Your security company might program relays for
automatic control and/or control from your keypad of
devices such as premises lighting or entry gates.
Contact them for further information regarding the use
of relays in your security system.
1. Ensure your keypad shows idle disarmed text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 5 button and then the 4 button.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the CHG RELAYS
button, press it.
4. The keypad display changes *Change Relay*
Enter relay number.
Valid entries are 1 to 128, depending how the
system is configured.
Enter the relay number then press the ENTER
button.
5. If the relay is valid and turned off, the display
changes to Change Relay* Relay 123 is
currently off.
(123 is used as an example.)
Press the Turn on button to turn on the relay.
6. If the relay is valid and turned on, the display
changes to
Change Relay* Relay 123 is
currently on.
(123 is used as an example.)
Press the Turn off button to turn off the relay.
7. The display returns to the *Change Relay*
Enter relay number.
Press the Exit button to return to idle text.
The on-board relays use the following
numbers:
Relay A 250
Relay B 251
Relay C 252.
Change Passcode (CMD + 5 + 5)
Description
Use this function to change your personal passcode
without assistance from the security company.
Before you begin:
Choose a new passcode three to six digits long. If
you choose a passcode with the same digit in
consecutive order (for example “33” in 334697),
take care when entering it.
To avoid conflicting with other passcodes and
duress codes, your system will not let you change
passcodes to an existing passcode or to within plus
or minus 2 of an existing passcode. For example, if
1234 were an existing code, your system would not
let you change your code to 1232, 1233, 1234,
1235, or 1236.
Using Change Passcode
1. Ensure your keypad shows idle disarmed text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 5 button and then the 5 button.