Filter
Top Products
D1265 | Owner's Manual | Part II: System Commands
16 Bosch Security Systems, Inc. | 9/10 | F01U169130-02
Passcode Protected Commands and
Functions
Commands and/or Functions within your system
might be programmed to require a valid passcode
prior to gaining access to that function. This ensures
that only authorized people have access to specific
functions.
1. The display might prompt you to enter your
passcode.
2. The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all passcode digits (from
a minimum of 3 to a maximum of six) are
entered.
3. Press ENTER.
Turning the System On (Arming)
Your security system can be turned on (armed) in
many different ways, depending on the arming
command used. Arming Commands are those
commands used to turn the system on. The most basic
arming command is to arm the entire system.
There are several other arming commands to turn the
system on. These are described later in this manual.
To Turn Your Security System On (Arm)
1. Enter your passcode and press ENTER.
2. After you arm your system, the keypad emits a
repeating beep tone, shows Exit now! #
seconds remaining and counts down the exit
delay time.
Turning the System Off (Disarming)
Entering your personal passcode turns off your security
system. When the system is turned on, you must enter
through a designated entry door to prevent an instant
alarm condition. Opening the door starts entry delay
time and the keypad emits a pulsing “beep” tone to
remind you to turn the system off. Enter your passcode
before the delay time expires and the system turns off.
If you enter through the wrong door or fail to disarm
before the entry delay time expires, you cause an
alarm.
If this happens, silence the alarm (by entering your
personal passcode and pressing ENTER) and call your
security company to let them know that it is not an
emergency situation.
If enabled by your security company,
there is a short period of time after the
start of the alarm that a passcode entry
aborts the transmission of the alarm
report. Alarm Aborted shows if this
occurs.
To Turn Your Security System Off (Disarm):
1. Enter your passcode and press ENTER.
2. You must press the ENTER button within 5 sec
of entering your passcode, or the passcode entry
is invalid.
3. The display returns to idle disarmed text.