Filter
Top Products
D1265 | Owner's Manual | Part III: Advanced Commands
40 Bosch Security Systems, Inc. | 9/10 | F01U169130-02
4. The display changes to show that all the doors
are at a normal state except for Door 3, which is
cycled.
The display will return to the door number
when the cycle command is complete.
5. Enter another door number to cycle or press
the Exit button to leave this function.
Unlock Door
1. If you wish to unlock an access door to allow
free access, press the Unlock Door button.
2. The display reads *Unlock Door*1 2 3 4 5 6 7
8 if all door are at a normal state and are
available.
If a door is not at a normal state, the number of
the door would be replaced with a symbol
indicated in Table 3.
3. Enter the number of the door you wish to
unlock then press the ENTER button. This door
is unlocked and the display changes to reflect
the new status of the doors.
For example, if you wanted to unlock Door 3,
press
3
then press the ENTER button.
The display changes to show that all the doors
are at a normal state except for Door 3, which is
unlocked.
4. Enter the door number again to return it to the
normal mode. The display shows the door
number again.
5. Press the Exit button to leave this function.
Secure Door
1. If you wish to unlock an access door to allow
free access, press the Unlock Door button.
2. The display reads *Secure Door*1 2 3 4 5 6 7 8
if all door are at a normal state and are
available.
If a door is not at a normal state, the number of the
door would be replaced with a symbol indicated in
Table 3 on page 39.
3. Enter the number of the door you wish to secure
then press the ENTER button. This door is
secured and the display changes to reflect the new
status of the doors.
For example, if you wanted to secure Door 3,
press 3 then press the ENTER button.
The display changes to show that all the doors are
at a normal state except for Door 3, which is
secured.
4. Enter the door number again to return it to the
normal mode. The display shows the door number
again.
5. Press the Exit button to leave this function.