Filter
Top Products
D1265 | Owner's Manual | Part III: Advanced Commands
Bosch Security Systems, Inc. | 9/10 | F01U169130-02 33
Unbypass A Point (CMD + 0 + 0)
Description
Unbypassing a point is a way to return a bypassed
point to the security system so that it can once again
respond to trouble and alarm conditions.
Using Unbypass a Point
1. Ensure the display shows disarmed idle text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 0 button twice.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the Unbypass a Point
button, press it.
4. You might be prompted for your passcode. It
appears on the display as asterisks (*).
5. The display changes to show Enter point
number or press next key.
6. If digits are pressed, the display shows Enter
point number: #. As soon as a digit button is
pressed, the display changes to Entering point
number (# is the point number that was
entered).
If you know the point number you wish to
unbypass, enter the number and press the
ENTER button.
If you don’t know the number of the point you
wish to unbypass, you can view the list of
devices that can be unbypassed by pressing the
Next button.
Continuously pressing Next scrolls through the
available points that are currently bypassed.
When the point text of the point you wish to
unbypass appears, press the Unbypass button.
One of the following messages shows (P3
ENTRY DELAY is used here as an example):
P3 ENTRY DELAY is now bypassed indicates
the point was successfully bypassed.
Invalid point Please try again indicates that
the entered point doesn’t exist and the display
returns to allow another point to be entered.