Filter
Top Products
D1265 | Owner's Manual | Part III: Advanced Commands
Bosch Security Systems, Inc. | 9/10 | F01U169130-02 31
User Passcodes
A three to six digit number entered at a keypad to access the system.
Bypass a Point (CMD + 0)
Description
This command allows you to bypass points that you do
not want included in the system. Points that are not
included in the system do not detect intruders and
cannot send any reports. You can bypass points when
an area is disarmed. Bypassing a point reduces the
level of security and should be used with discretion.
Points remain bypassed until you unbypass them, or
some points might return when the area is disarmed
(refer to Unbypass a Point (CMD + 0 + 0) on page 33).
You could use CMD 0 to leave a window open over
night without initiating an alarm. Also refer to Turning
On the System (Arming) With Doors or Windows Open on
page 17.
Using Bypass a Point
1. Ensure your keypad shows idle text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 0 button.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the Bypass a Point
button, press it.
4. You might be prompted for your passcode. It
appears on the display as asterisks (*).
5. The display changes to show Enter point
number or press next key.
6. If a digit is pressed, the display shows Enter
point number: #. As soon as a digit button is
pressed, the display changes to Entering point
number (# is the point number entered).
If you know the point number you wish to
bypass, enter the number and press the ENTER
button.
If you don’t know the number of the point you
wish to bypass, you can view the list of devices
that can be bypassed by pressing the Next
button.
Continuously pressing Next scrolls through the
available points that can be bypassed.
When the point text of the point you wish to
bypass appears, press the Bypass button.
P3 ENTRY DELAY is not bypassed indicates
the point is not bypassed and the option is
given to bypass it.
One of the following messages shows (P3
ENTRY DELAY is used here as an example):