Filter
Top Products
Page S-A2 Instruction 2772-0803
REMOTE INTELLIGENT SENSOR - AREA MONITOR
Adjustment method ‘b’. Remove the cassette and pull out a loop of several
inches of tape. Insert a portion in the gate while the cassette is held in one hand; or
placed on the top of the RIS. Do not touch tape with bare fingers to avoid
contact with the chemicals on the tape.
With the tape in the gate and the cassette supported in one hand, adjust the
potentiometer with the other hand until the reading is 220. Counterclockwise
rotation of potentiometers increases the level.
When track 1 has been adjusted by either of the above methods, press the
HOLD/RELEASE button to allow track 2 to be displayed. HOLD this display as
before and adjust the same as track 1.
After adjustments have been made, rewind the tape pulled out of the cassette
(if the second method was used). Replace the cassette and close the gate. Exit the
TEST Mode by pressing the red button on the rear of the door again, unless other
tests have to be done.
Exit the TEST Mode by pressing the red button on the rear of the door again,
unless other tests have to be done.