Parameters
address Enter a single address to be excluded from the pool.
low-address Enter the lowest address in a range of addresses to be
excluded from the pool.
high-address Enter the highest address in a range of addresses to be
excluded from the pool.
Defaults none
Command
Modes
DHCP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
hardware-address
For manual configurations, specify the client hardware address.
Z9500
Syntax
hardware-address address
Parameters
address Enter the hardware address of the client.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
710
Dynamic Host Configuration Protocol (DHCP)
