Version Description
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
The source-interface interface attribute is applicable for both the SSH
client
as well as the COPY (SCP) commands. Using these attributes the client
session tags an error to the user during run time, in case there is a mismatch
between this command and the ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 0/36
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface
show crypto
Display the public part of the SSH host-keys.
Z9500
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
show crypto key mypubkey {rsa | rsa1}
Parameters
Key Enter the keyword key to display the host public key.
mypubkey Enter the keyword mypubkey to display the host public key.
rsa Enter the keyword rsa to display the host SSHv2 RSA public
key.
rsa1 Enter the keyword rsa1 to display the host SSHv1 RSA public
key.
NOTE: If you enable FIPS mode, this parameter is not
available.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
Security
1669
