mode do not inherit the global BFD enable/disable values configured with the
bfd all-neighbors command or configured for the peer group to which a
neighbor belongs. The neighbors inherit only the global timer values.
You can only enable BFD for VRRP in INTERFACE command mode (vrrp bfd
all-neighbors
).
Related
Commands
show bfd neighbors — displays BFD neighbor information on all interfaces or a
specified interface.
neighbor bfd disable — explicitly disables a BFD session with a BGP neighbor or a
BGP peer group.
bfd disable
Disable BFD on an interface.
Z9500
Syntax
bfd disable
Re-enable BFD using the no bfd disable command.
Defaults BFD is disabled by default.
Command
Modes
VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on S4810.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Bidirectional Forwarding Detection (BFD)
347
