neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name
{in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-
group-name} route-map map-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
map-name Enter the name of an established route map. If you do not
configure the Route map, the default is deny (to drop all
routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
550
Border Gateway Protocol
