Command
Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip
udf-qualifier-value ipnip_val1
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500.
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — creates an extended ACL.
show config
Display the current UDF TCAM profile configuration.
Syntax
show config
Command
Modes
CONFIGURATION-UDF TCAM
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500.
Example
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
key innerL3header udf-id 6 packetbase innerL3Header offset 0
length 2
match l2ethertype ipv4 ipprotocol 4 vlantag any
!
udf-qualifier-value ipnip_val1
Dell(conf-udf-tcam)#
Access Control Lists (ACL)
341
