debug ip bgp events
Display information on local BGP state changes and other BGP events.
Z9500
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] events [in | out]
To disable debugging, use the no debug ip bgp [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] events [in | out] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display BGP state changes corresponding to that
VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group
peer-group-
name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only events on
inbound BGP messages.
out (OPTIONAL) Enter the keyword out to view only events on
outbound BGP messages.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol
397
