Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced on the E-Series.
Related
Commands
monitor session — enables a monitoring session.
monitor multicast-queue
Configure monitor QoS multicast queue ID.
Syntax
monitor multicast-queue queue-id
To remove the configuration, use the no monitor multicast-queue
command.
Parameters
queue-id Enter the QoS multicast queue ID. The range is from 0 to 9.
Defaults
queue-id: 0
Enable status: Disabled
Command
Modes
CONFIGURATION
Example
Dell(conf)#monitor multicast-queue 7
1436
Port Monitoring
