Filter
Top Products
Tools Needed:
8
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Horizontal Angle
Hammer
Attaching Fully Adjustable Flagangle
to Vertical Track
NOTE: If quick install flagangles were installed in
Step 1, skip this step and continue with Step 3.
Hand tighten the flagangle to the vertical track
using (1) stud plate and (2) 1/4” - 20 flange hex
nuts. Repeat for other side.
Secure the flange nuts after flagangle spacing is
complete (Step 10).
None
2
3
Position the horizontal angle as shown.
Place tabs of horizontal angle in the key slot of
horizontal track. Using a hammer, tap the horizontal
angle towards the curved end of the track until the
holes in track and angle are aligned. Repeat for
opposite side. Set tracks aside.
NOTE: For larger doors, a full length horizontal angle
may be spot welded to the horizontal track. If the
horizontal angle is not welded, the horizontal angle
must be installed as shown.
(2) 1/4”- 20 Flange
hex nuts
Fully adjustable
flagangle
Vertical track
Stud plate
Horizontal angle
Hole
Tabs
Key hole slot
Horizontal track
Hole
Horizontal angle
Horizontal track
Horizontal angle
Horizontal track
Tabs