Filter
Top Products
Tools Needed:
None
15
Center Bracket Assembly
NOTE: If you are installing the
i
drive
®
opener with
your garage door, skip this step and go to your
i
drive
®
Installation Instructions and Owner’s Manual.
After completing steps 1-13 of your idrive Installation
Instructions and Owner’s Manual, rear supports
NOTE: If you are not installing the
i
drive
®
opener on
your garage door, you must install the center bracket
bushing assembly. Follow these instructions for
non-
i
drive
®
operated garage doors.
Being cam shaped the center bracket assembly only
fits one way.
Slide the center bracket assembly towards the center
of the TorqueMaster
®
spring tube assembly, from the
right side as shown.
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER
®
SPRING TUBE
ASSEMBLY
TORQUEMASTER
®
SPRING TUBE
ASSEMBLY
CENTER
BRACKET
BUSHING
Shake the TorqueMaster
®
spring tube assembly
gently to extend the winding shafts out about 5" on
each side. For single spring applications, there will
be no left hand spring in the TorqueMaster
®
spring
tube assembly.
Lift the TorqueMaster
®
spring tube assembly and
rest it on the top of the flagangles.
NOTE: Cable drums are marked right and left hand
Cable drums and TorqueMaster
®
spring tube
assembly are cam shaped to fit together only one
way.
Starting on the right hand side, slide the drum wrap
over to access the counterbalance cable. Now, pre-
wrap the right hand cable drum with the counter
balance cable 1-1/2 wraps as shown.
Position the Torquemaster
®
spring tube assembly so
the cam peak is pointing straight up. Slide cable
drum over the winding shaft until the cable drum
seats against the TorqueMaster
®
spring tube
assembly.
The winding shaft must extend past the cable drum
far enough to expose the splines and the groove.
Align the winding shaft groove with the round notch
in the flagangle.
Tape Measure
Step Ladder
Tools Needed:
16
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
15
RIGHT DRUM
TORQUEMASTER
®
SPRING
TUBE ASSEMBLY
1-1/2 Wrap Shown
COUNTERBALANCE
CABLE
Cable Drums
16
CAM PEAK
STRAIGHT UP
WINDING
SHAFT
5”