Filter
Top Products
NOTE: If you have fully adjustable flagangle, skip
this step and complete Step 12.
To install horizontal track, place the curved end over
the top roller. Align key slot of the horizontal track
with the quick install tab of the flagangle. Push
curved portion of horizontal track down to lock in
place.
Level the horizontal track assembly and bolt the
horizontal angle to the slot in the flagangle using (1)
3/8” - 16 x 3/4” truss head bolt and (1) 3/8” - 16
hex nut. Repeat for other side.
NOTE: If an
i
drive
®
opener will be installed, position
horizontal tracks slightly above level.
Remove the nail that was temporarily holding the
top section in place, installed in Step 10.
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE SE-
CURED AT REAR, AS OUTLINED
IN STEP 24, OR DOOR COULD
FALL FROM OVERHEAD POSI-
TION CAUSING SEVERE OR FATAL
INJURY.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
NOTE: After completing this step, continue with
step 13.
KEY SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
11
9/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Step Ladder
Attaching Horizontal Track to Quick
Install Flagangle
WARNING
(1) 3/8”- 16 X 3/4”
TRUSS HEAD BOLT
(1) 3/8”- 16
HEX NUT
HORIZONTAL
TRACK
HORIZONTAL
ANGLE
KEY SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
Attaching Horizontal Track to
Fully Adjustable Flagangle
NOTE: If quick install flagangles were installed in Step 11,
skip this step and continue with Step 13.
To install horizontal track, place the curved end over the top
roller. Align the bottom of the horizontal track with the vertical
track. Hand tighten the horizontal track to the flagangle with
a stud plate and (2) 1/4”-20 flange hex nuts.
Level the horizontal track assembly and bolt the horizontal
angle to the slot in the flagangle using (1) 3/8” - 16 x 3/4”
truss head bolt and (1) 3/8” - 16 hex nut. Repeat for other
side.
NOTE: If an idrive
®
opener will be installed, position horizontal
tracks slightly above level.
Remove the nail that was temporarily holding the top section
in place, installed in Step 10.
DO NOT RAISE DOOR UNTIL HORIZONTAL
TRACKS ARE SE CURED AT REAR, AS
OUTLINED IN STEP 24, OR DOOR COULD
FALL FROM OVERHEAD POSI TION
CAUSING SEVERE OR FATAL INJURY.
IMPORTANT: FAILURE TO REMOVE NAIL BEFORE
ATTEMPTING TO RAISE DOOR COULD CAUSE
PERMANENT DAMAGE TO TOP SECTION.
12
WARNING
1/4”-20 FLANGE
HEX NUTS
FLAGANGLE
(1) 3/8”- 16 X 3/4”
TRUSS HEAD BOLT
(1) 3/8”- 16
HEX NUT
HORIZONTAL
TRACK
HORIZONTAL
ANGLE
Stud plate
Tools Needed:
Tools Needed:
14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
11
12
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Step Ladder