Filter
Top Products
7
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and header must be level. Side clearance,
from edge of door to wall, must be a minimum of 3-1/2” (89mm) on each side.
IMPORTANT: STAINLESS STEEL OR PT 2000 COATED LAG SCREWS (NOT SUPPLIED) MUST BE USED WHEN INSTALLING CENTER
BEARING BRACKETS, END BRACKETS, JAMB BRACKETS, OPERATOR MOUNTING/SUPPORT BRACKETS AND DISCONNECT BRACKETS
ON TREATED LUMBER (PRESERVATIVE-TREATED). STAINLESS STEEL OR PT 2000 COATED LAG SCREWS ARE NOT NECESSARY WHEN
INSTALLING PRODUCTS ON UNTREATED LUMBER.
IMPORTANT: WHEN INSTALLING 5/16” DIAMETER LAG SCREWS USING AN ELECTRIC DRILL/DRIVER, THE DRILL/DRIVER’S CLUTCH MUST
BE SET TO DELIVER NO MORE THAN 200 IN. LBS. OF TORQUE. FASTENER FAILURE COULD OCCUR AT A HIGHER SETTING.
NOTE: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit, prior to fastening.
Installation
INSTALLATION
None
Attaching Quick Install Flag
Angle to Vertical Track
NOTE: If you have fully adjustable flagangles, skip
this step and complete Step 2.
Place the lower quick install tab of the flagangle in
the quick install feature of the vertical track. Give
the flagangle 1/4 turn to lock in place. Repeat for
other side.
NOTE: After completing this step, continue with
Step 3.
QUICK INSTALL TAB UNLOCKED
QUICK INSTALL TAB LOCKED
FLAGANGLE
VERTICAL
TRACK
1
LEFT HAND TRACK AND FLAGANGLE
RIGHT HAND TRACK AND FLAGANGLE
FLAGANGLE
VERTICAL
TRACK