Filter
Top Products
Tools Needed:
10
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Drums
IMPORTANT: RIGHT AND LEFT HAND
IS ALWAYS DETERMINED FROM INSIDE
THE BUILDING LOOKING OUT.
NOTE: For door section identification see page 4.
TorqueMaster
®
drums are marked right and left
hand. Uncoil the counterbalance cables and make
sure you place the right hand cable loop on the
right hand milford pin and place the left hand
cable loop on the left hand milford pin. Check to
ensure the cable loop fits tightly over the milford
pin.
Failure to ensure tight fit of cable
loop over milford pin could result
in cable coming off the pin and
allowing door to fall, possibly
resulting in severe or fatal injury.
Bottom section: Insert roller into bottom roller
carrier hole and insert another roller into the inner
roller carrier hole, located at the top of the bottom
section.
Lock section: Insert roller into the inner roller
carrier hole.
Intermediate section I: Insert roller into the
outer roller carrier hole.
Intermediate section II (5 section- 8’ Height
only): Insert roller into the Outer roller carrier hole.
None
5
BOTTOM
SECTION
ASTRAGAL
MILFORD
PIN
Bottom Section
Bottom roller
carrier hole
Rollers
Milford pin
Inner roller
carrier hole
Outer roller
carrier hole
Inner roller
carrier hole
Lock and Intermediate Sections
Left hand
counterbalance drum
Top roller
carrier
WARNING