Filter
Top Products
Tools Needed:
13
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Top Section
Place the top section in the opening and vertically
align with lower sections.
Temporarily secure the top section by driving a
nail in the header near the center of the door and
bending it over the top section.
Now flip up hinge leaf against section, fastening
center hinges first, and end hinges last. (Refer to
Step 8).
When installing a door with Torquemaster
®
Plus
counterbalance system, vertical track alignment
is critical.
Position flagangle between 1-11/16” (43 mm)
to 1-3/4” (44 mm) from the edge of the door.
Tighten the bottom lag screw. Flagangles must be
parallel to the door sections.
Repeat for opposite side.
IMPORTANT: THE DIMENSION
BETWEEN THE FLAGANGLES MUST BE
DOOR WIDTH PLUS 3-3/8” (86 MM) TO
3-1/2” (89 MM) FOR SMOOTH, SAFE
DOOR OPERATION.
Now complete the vertical track installation by
securing the center jamb bracket (s), flagangle,
and connection of the vertical track/ flagangle.
Repeat for opposite side.
10
Hammer
Nail
Tape Measure
Step Ladder
1-11/16” TO 1-3/4”
FLAGANGLE
TOP
SECTION
NAIL
TOP SECTION
Door width +
3-3/8” - 3-1/2”