Filter
Top Products
– 200 –
Fan motor Fan motor
Propeller fan Loosened by
turning clockwise
Flange nut
Propeller fan
Propeller fanPropeller fan
Loosened by
turning clockwise
Flange nut
Fan motorFan motor
Connector of
upper fan motor
Connector of
lower fan motor
Ferrite core of
lower fan motor
Connector of
upper fan motor
Connector of
lower fan motor
Ferrite core of
lower fan motor
Fan motor lead
fixed rubber
Projection/Refrigerating
cycle side
Fan motor lead
fixed rubber
Projection/Refrigerating
cycle side
Projection/Refrigerating
cycle side
Projection/Refrigerating
cycle side
Fan motor lead
fixed rubber
Fan motor lead
fixed rubber
No.
5
Part name
Fan motor
Procedure
1) Carry out works of item 1 of
1
and work of
2
.
2) Remove the flange nut fixing the fan motor
and the propeller fan.
• The flange nut is loosened by turning it
clockwise. (When tightening it, turn it
counterclockwise.)
3) Remove the propeller fan.
4) Remove the connector for the fan motor from
the inverter. (Remove the ferrite core of the
lower fan motor because it is used.)
5) Remove the fan motor lead from the fan
motor lead fixed rubber of the penetrated part
of the partition board.
6) Remove the fixing screws (4 pieces each)
while supporting the fan motor so that it does
not fall down.
∗ Cautions for assembling of fan motor
• Tighten the flange nut with 4.95N•m
(50kgf•cm).
• Adjust length of the fan motor lead wire at
the fan motor lead fixed rubber so that the
fan motor lead is not slackened; otherwise
the fan motor lead may come to contact
with the propeller fan.
Attach the fan motor lead fixed rubber to
the partition board so that the projection is
set at the refrigerating cycle side.
• Be sure so that the rector body does not
contact with the fan motor lead.
• Be sure to bundle the removed bundling
band with the bundling band on the
market.
• Necessarily attach the ferrite core of the
lower fan motor again.
(Fix it with bundling band on the market.)
XREQUIREMENTX
Be sure to fix the fan motor lead to the
motor base using the metal band of the
motor base so that the fan motor lead does
not come to contact with the propeller fan.
Remarks